Straumann SP & BLT - bridge, how to do correctly?

106 Rating(s).

Posted on 04.25.2022 05:08 AM By Vad Sand In Implants

Dear collegues, im interested in how to do proper prosthetic part in case i have to connect two implants one of them is SP and other is BLT ??? I plan to produce temporary metal-to-PMMA brigde and further after that permanent zirconia-reiforced with metal bar bridge. i want to have most passive brigde fit on platforms but using screw -retained prosthesis. is it possible to avoid cement type of fixation? X-ray attached below. Which prosthetic parts should i select for performing that operation? Great thanx for answers and considerations

opg

healing abutments

Respond to Case

Add a comment to the discussion on Straumann SP & BLT - bridge, how to do correctly?

Case has been added to your favorites.

Case has been removed from your favorites.

Thank you for your input. Your comment has been posted.

You are now following this member. You will get notified on any new topics posted by this member.

You are no longer following this member. You will not get notified on any new topics posted by this member.

Edit Comment

Comment has been updated.

4 Comments

Maurice Salama says on 04.25.2022 01:03 PM

Vad; Were these recently placed implants? Did you perform the Sx? I would suggest you speak to a Straumann Rep or Lab that uses these platforms and systems to give you the best advice. Regards Dr. Salama

Kremena Ivanova says on 04.30.2022 01:51 PM

Hellow Vad Sand
Is this what you are looking for?
https://www.straumann.com/content/dam/media-center/medentika/en/documents/brochure/product-information/PM01_01_0021_%20EN_Multi-unit.pdf

Dr. Avijit says on 05.04.2022 03:30 AM

Were these implants that had recently been implanted? Did you carry out the Sx?

Dr. Avijit says on 06.07.2022 01:30 AM

I would recommend speaking with a Straumann Representative or Lab that uses these platforms and systems to get the best guidance. Regards Salama, Dr.